- Frequency Range: 155-158 MHz
- RF Power Scale: 0 to 30 watts
- Impedance: 50 ohms
- Accuracy: +/-10%
- Connectors: SO-239
- Signal Generator: 3 KHz Deviation
- Tone: 1000 Hz
- RF Level: -115 dBM (approx.)
- Style 4079 one-meter cable available (sold separately) to connect the ART-2 or ART-3 to your VHF Radio or for the Style CS-2 Switch. It has PL-259 connectors on each end already installed.
- It is powered by an internal battery or can be connected to ships 12 VDC with the supplied power cable. Battery level can be checked at the flip of a switch. No serious boater should be without an ART-3.
The ART-3 provides a quick and easy way to check any antenna installation.
1. Connect the meter in‐line with the antenna from the VHF.
2. Calibrate the meter.
3. View the VSWR reading.
5. If a high reading locate the problem.
Testing the receiver of the VHF utilises a built in tone generator. Set the radio on the VHF to Ch72 – if no tone can be heard this would indicate a problem with the radio itself.
The unit is powered by an internal battery or can be connected to ships 12 VDC with the supplied power cable.
2. Calibrate the meter.
3. View the VSWR reading.
5. If a high reading locate the problem.
Testing the receiver of the VHF utilises a built in tone generator. Set the radio on the VHF to Ch72 – if no tone can be heard this would indicate a problem with the radio itself.
The unit is powered by an internal battery or can be connected to ships 12 VDC with the supplied power cable.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
