The DriveForce impeller puller is an impeller removal tool designed to help remove impellers
with a diameter up to 65mm from the pump without damaging the fragile pump body.

Traditional tools such as screwdrivers should not be used as these can easily damage the body
of the pump which may lead to pump failure.

Replacing an impeller is easy. By removing the end cover screws, it is possible to remove the impeller
by using an impeller removal tool even in confined spaces.

Remember it is important to always carry spare impellers on board in case of an emergency.
The impeller is one of the most vital components of the engine cooling system and should always
be treated as such.

New impellers should always be greased before installation as it makes it easy to install the impeller
into the pump bore and secondly it gives added protection to the impeller during initial prime.

Most Johnson Impeller kits are supplied with a small sachet of special grease to apply to the new
impeller when installing.

Please ensure that any impeller lubricant used is suitable for the impeller material and for your particular application.

The pump impeller puller is made from corrosion resistant materials for added peace of mind.